Worldwide Shipping And Paypal Buyer Protection :Free  Shipping for Orders over $49 +🔥 SUMMER SALE USE CODE "SUMMER10" TO GET 10% OFF ☀
USD

Installation and use of magnetic core bits (hollow bits)?
2021-06-09

The king asked me to patrol the mountain

    100 articles
    110,000 total reading

View TA's article>
comment

    0

share it

    WeChat Share
    Sina Weibo
    QQ space
    copy Link

Installation and use of magnetic core bits (hollow bits)
2018-04-14 20:27

1. The use of magnetic core bits: core bits (also known as hollow bits) can perform drilling operations on various steel plates, steel pipes, cast iron, stainless steel, aluminum, copper and various non-metallic materials. 2. Product type: Right-angle shank: suitable for imported and domestic brands of magnetic base drilling rigs. Examples: ALFRA, RUKO, HOUGEN, Rotabroach, BDS, Taiwanese brands, etc. Universal shank (quick shank): In addition to the Fein brand, it is suitable for other imported and domestic brands of magnetic base drilling rigs. Examples: ALFRA, RUKO, HOUGEN, Rotabroach, Japan, BDS, Taiwanese brands, etc. Four-hole shank (Fein type): suitable for German brand Fein drilling rigs.

3. How to use magnetic core drill (hollow drill):

1) Installation method:

A. Right-angle handle: align the two planes of the handle end with the two screw holes on the main shaft of the drill, tighten it with an Allen key with a gap of 0.2-0.3MM, and gently turn it back and forth by hand to confirm that the Allen screw is perpendicular to the two planes, then apply force Tighten the screws.

B. Universal shank: align the round hole on the shank end with the steel ball in the drill chuck and install it. The universal handle can also be fixed with hexagon socket screws, as long as the hexagon socket screws are vertically screwed on the handle end plane.

C. Four-hole handle:

1) Turn the safety ring on the main shaft clockwise to the position, insert the handle end directly and rotate it in a small range until the steel ball enters the round hole.

2) Feed rate: The feed rate is generally based on experience. From a numerical point of view, it is generally 0.08-0.12MM/rev, or 0.6-1.0MM/sec. The feed rate is a key element in drilling. Different feeds The given amount can form different iron filings, and different iron filings will change the performance of chip removal. 3) Positioning: Use a central chisel to hit a positioning point at the position where drilling is needed or use an alloy needle to make a "cross" line to ensure the accuracy of the drilling position. Note that when using the center chisel to hit the positioning point, please make sure that the center chisel is perpendicular to the surface of the workpiece, so as not to affect the smooth discharge of the cutting core.

4) Start drilling: adjust the appropriate speed, make sure the bottom of the drill magnetic base is clean before starting, turn on the magnetic base switch and then the motor switch, the motor is running and open the coolant switch at the same time, when the drill bit touches the steel plate, first feed slowly , After drilling about 1-2MM, feed at normal speed. 5) End of drilling: After turning off the motor and waiting for the spindle to stop rotating, use an iron hook to remove the iron filings wound on the drill body, and then continue the operation.

>> How should a broken drill be taken out of the workpiece?

Join our community

Subscribe To Our Newsletter